Thanks for the thoughtful response. One of the network architecture issues I'm always trying to gauge and get my arms around is what I'll call, "Quality of user experience." In other words, what mix of network hardware, software, customer support, and management will create a perception that the network is performing at maximum efficiency.
Although the perception of network performance is entirely subjective there are some factors that I'm sure we can all agree contribute to overall satisfaction...i.e. -WAN link latency. -Packet Loss. -Consistency in packet generation/serialization (A packet always enters interface A and leaves interface B in .5 ms) So, if all other elements (software, customer support, and management) are equal, what router hardware architecture will contribute to a positive or negative user experience? In other words, if the routing device between my workstation and server is a Juniper M7 instead of Pentium IV running unix-flavor-of-the-day, how will that affect the quality of user experience? Thank you, Christopher -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Lincoln Dale Sent: Friday, September 16, 2005 11:18 PM To: Christopher J. Wolff Cc: nanog@merit.edu Subject: Re: image stream routers Christopher J. Wolff wrote: > I'd be interested to know the relative pros and cons of switching packets in > software (Imagestream) versus handing them off to a dedicated ASIC (Cisco, > Juniper) [without having looked at Imagestream in any way, shape or form..] it would be _unlikely_ that any router vendor that wants to support >OC3 could do so with the 'standard' (non-modified) linux IP stack. if they are modifying the 'standard' linux IP stack then its very unlikely that one could do so without having to publish the source-code to it. (i.e. as per GPL). 'standard' linux on standard hardware isn't capable of much more than 100K PPS. sure - some folks have a few hundred packets/sec - but these are minimalist versus the demonstrated performance of ASIC-based forwarding, typically 30M-50M PPS. one advantage of software is programmability. if there is a bug you can fix it. if there is a bug in an ASIC, it may or may not be possible to fix it - it depends on awful lot on how the ASIC is built (whether its 100% fixed functionality or supports limited programmability in various stages of the forwarding pipeline). it may be that its not fixable but that the ASIC allows software-workarounds - in essence, 'fixing' something by diverting it to a (slower) software-path. note that there is a correction to make here: not all routers _ARE_ ASIC-based for forwarding. in fact, most of the Cisco /router/ product portfolio isn't hardware-forwarding based. generally speaking it isn't necessary - UNTIL you get to the point of having interface speeds & number-of-interfaces which exceed the capabilities of general-purpose processors. that is, typically somewhere between 100K PPS and 1M PPS. cheers, lincoln.