Thanks Mark - just found the same thing out myself :)
S
On Mon, 16 Jan 2006, Mark Smith wrote:
On Mon, 16 Jan 2006 00:24:35 +0000 (GMT Standard Time)
Sam Stickland <[EMAIL PROTECTED]> wrote:
On Mon, 16 Jan 2006, Mark Smith wrote:
On Sun, 15 Jan 2006 23:50:07 +0000 (GMT Standard Time)
Sam Stickland <[EMAIL PROTECTED]> wrote:
Hi,
<snip>
The cabling arrangement is:
Foundry -- Straight -- Patch -- Underfloor -- Patch -- Crossover -- Cisco
GBIC Cable Panel Straight Panel Cable
If I replace the final crossover cable with a straight,
Just do that ^^^ and give it a try.
Will do.
Having done a bit more looking into this myself, one thing that might be
a cause is the cross-over, in the sense that if it is a 100BASE-T
crossover, only two of the pairs will be crossed, and the other two
pairs are usually wired straight.
A GigE cross over, assuming you need one if you're ports don't support
automatic cross over, has all four pairs crossed over
(1-3,2-6,3-1,6-2,4-7,5-8,7-4,8-5). My guess would be that if a device
only detects two of the four pairs crossed, it drops back to 100BASE-T.
In other words, GigE cross overs are backwards compatible with
10/100BASE-T, but 10/100BASE-T crossovers aren't forward compatible with
GigE.
A GigE rated straight through path would be the first thing I'd test,
after that, possibly try a GigE crossover somewhere between the devices.
Regards,
Mark.
--
"Sheep are slow and tasty, and therefore must remain constantly
alert."
- Bruce Schneier, "Beyond Fear"