You can order programmable relay controllers from Newark or Allied electronics. Omron makes some good ones for this test. They run about $150.
The inductor will have to be custom built using "E" and "I" cores and if done correctly will weigh about 75 to 100 pounds (assuming you need to source any amount of current over a few amps). Good Luck, Jim Jim Wiese NEBS Project Manager/Compliance Engineer ADTRAN, INC. 901 Explorer Blvd. P.O. Box 140000 Huntsville, AL 35814-4000 256-963-8431 256-963-8250 fax jim.wi...@adtran.com > ---------- > From: Jerry Martin[SMTP:martin_je...@juno.com] > Sent: Wednesday, October 06, 1999 12:33 AM > To: t...@world.std.com; emc-p...@ieee.org; nebs@world.std.com > Subject: SBC TP76200MP DC Power Requirements > > Does anyone have any experience with SBC's TP76200MP document? > > I'm specifically looking for information on how to do some of the tests > in Section 8 "DC Power". > > Where can I get/make an "Electronic Switch/Relay" of Figures 8-3 and 8-5? > > Where can I get/make the 0.08 H inductor? > > Any help is appreciated. > > Thanks, > > Jerry > > ___________________________________________________________________ > Get the Internet just the way you want it. > Free software, free e-mail, and free Internet access for a month! > Try Juno Web: http://dl.www.juno.com/dynoget/tagj. > --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to majord...@ieee.org with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to ed.pr...@cubic.com, jim_bac...@monarch.com, ri...@sdd.hp.com, or roger.volgst...@compaq.com (the list administrators).