I'm about to replace both my gray water and black water tanks due to
age and cracking and I'm on the fence on the way to go on a few
things.
I found the correct replacement tanks @ Inca plastics, so that part
is done. I'm looking at going back with PVC in place of the ABS that
was original. Does anyone know why that would not work?
I'm also looking at the rubber seals that the drain pipes slip
through in place of the threaded connections on the original tanks.
I would think that there would be less stress on the pipe going that
route. Any thoughts as to why this would not work better?
Last are there any major diference in tank sensors or are they all
pretty much the same?
Any suggestions appreciated.
Andy Anderson
1979 32' Kings Highway
| Yahoo! Groups Sponsor | |
|
|
Yahoo! Groups Links
- To visit your group on the web, go to:
http://groups.yahoo.com/group/classicrv/
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
