There are two "jumper blocks" on the board. J3 has the generated signals, and J4 connects 1-to-1 to the octal socket pads. Obviously, a B13B socket won't just plug into the holes meant for an octal socket. But with short pieces of solid hookup wire, you can suspend that 13pin socket over the octal pads. Here's a drawing if you want to use a Z504S:
<https://lh4.googleusercontent.com/-e2mqiMvV4tM/UegcjfQa5lI/AAAAAAAAKtY/bQLaR5Me8Wk/s1600/B13B_jmpr.gif> I flipped the Z504S pinout, so it shows the top view. In the data sheets its usually the bottom view, which would be a mirror image. The letters in red are the suggested jumpering, from J3 to J4. Only a suggestion. You can then solder in the hook up wires into those pads, and tie them to the corresponding signals on the B13B socket. Assuming a Z504S dekatron. On Thursday, July 18, 2013 2:06:23 AM UTC-7, kay486 wrote: -Very nice kit! I wonder, how hard would it be to modify it for B13B base dekatrons? -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/3bae4447-8908-4973-a677-7218236a5783%40googlegroups.com. For more options, visit https://groups.google.com/groups/opt_out.
