Hey Jim,
I replaced all our buss/2-mix pots with 91A1A-B24-B18 (bourns). You
will need to bend the legs a bit to make them work.
For the bus master module, you should mount the faceplate to the pcb
with a couple of L brackets. From the factory, the pots hold the
face plat to the board, which is dumb.
This is what the module looks like after it's done-
http://greg.electrical.com/Neotek/Series%202%20Recap/07-30-08_1437.jpg
Good luck,
Greg Norman
Electrical Audio Recording
773.539.2555
www.electrical.com
On Apr 27, 2009, at 4:10 PM, Jim wrote:
anybody know where to pick up some spare pots? are they made by noble?
thanks
-jim
------
View the list online at: http://www.mail-archive.com/
[email protected]
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe neotek" in the
message body. If you have any difficulties, or questions --please
send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that
any message or reply sent to the list will be automatically
forwarded to all subscribers.
Vive Le Neotek!
Thanks.
------
View the list online at: http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any message
or reply sent to the list will be automatically forwarded to all subscribers.
Vive Le Neotek!
Thanks.
