Hi
You should be able to work out which is the pos and neg supply by
tracing it from the power pins of the ICs, which go through 47 or 100
Ohm resistors. The capacitors that are involved in the supply will show
which is pos and which is neg.
From what I remember of other 1 series modules the input and insert
points are marked with copper print which only leaves the 'output'.
There will be stubs of wire or just the holes in the board which are a
give away! Follow the trace from the bus mix resistors back to the
routing switches and take the output from there although this will be
'panned'. For a pre pan signal take it from the pan pot common.
Matt S
Hi I want to rack two Series 1E modules and I am looking for pinout
information. Is there any chance you can help?
thanks,
Steve
------------------------------------------------------------------------
Can't afford a new spring wardrobe? Go shopping in your closet instead
<http://www.stylelist.com/spring-fashion/spring-style/shopping-in-your-closet?ncid=emlweusstyl00000001>!
------
View the list online at: http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any message
or reply sent to the list will be automatically forwarded to all subscribers.
Vive Le Neotek!
Thanks.
