Thanks Brent! Gotta' love this list, thanks for hosting it, Jim!
best to all,
Ike
On 11-05-04 12:16 AM, Brent Punshon wrote:
On our 86 Elite the control knobs and caps are a mixture of 11mm and
15mm made by Sifam.
http://www.sifam.com/knobs.asp
Check these details as it's been a while. I seem to recall the metric
shaft measurement being correct (as opposed to the standard version)
but definitely check that too. This is what I have written down:
Conventional push on control knobs:
DB110 004 GRY (Base dia 11.5mm, height 14.4mm, 4mm shaft/ 2.5mm flat)
D shaft with compression ring
DA150 006 GRY (Base dia 15.5, height 14.6mm, 6mm shaft/5mm flat) D
shaft with compression ring
Caps:
C111 blue/9 (blue 11mm with line) also (grey/6, black/5, red/7 etc)
C151 grey/6 (grey 15mm with line) " "
Again, double check all this, but it's close to right from memory. I
replaced our whole board's caps and some knobs. Note the knobs are
conventional push-on D shaft, not collet (although I've oversized our
monitor pot knob and used a collet there).
Hope that helps.
Brent Punshon
P.S. there you go Ike, some info for you for once!
On 4/05/2011 8:52 AM, davids39@b igplanet.com wrote:
Can anyone tell me the brand of knobs used on a 93 Elite? I need some
caps and need to find a supplier. If you can tell me the sizes of the
knobs (those in the master section) in millimeters it would be great!
------
View the list online at:
http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe neotek" in the
message body. If you have any difficulties, or questions --please
send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any
message or reply sent to the list will be automatically forwarded to
all subscribers.
Vive Le Neotek!
Thanks.
------
View the list online at:
http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe neotek" in the
message body. If you have any difficulties, or questions --please send
an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any
message or reply sent to the list will be automatically forwarded to
all subscribers.
Vive Le Neotek!
Thanks.
--
Ike Zimbel,
Zimbel Audio Productions Ltd.
Toronto
416-720-0887
"Studio House Calls". Authorized Warranty service for Allen& Heath, Clear-Com,
Drawmer, Soundcraft, SPL and Yamaha. Repairs and upgrades to analog audio equipment
including: AMEK, dbx, Neve, Neotek, MCI, Soundcraft and more. Ask about our RF frequency
co-ordination services!
www.zimbelaudio.com
------
View the list online at: http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any message
or reply sent to the list will be automatically forwarded to all subscribers.
Vive Le Neotek!
Thanks.
