Hey Jim! There is, and we have both a crimper (http://www.redco.com/shopexd.asp?id=862) and extraction tool (http://www.redco.com/shopexd.asp?id=386).
We used them for installing EDAC/ELCO's for the console bus outs and tape returns. You're more than welcome to borrow both. Thanks, Wm Schwartz Catapult Sound -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jim Sent: Tuesday, January 17, 2012 10:47 AM To: [email protected] Subject: NEOTEK: ECLO pin tool Greetings, What is the correct tool to use to remove and install pins in an ELCO connector? Specifically, the (if it matters) ELCO type used for ADATs. Many thanks! Regards, Jim ------ View the list online at: http://www.mail-archive.com/[email protected] You can unsubscribe at anytime by sending an email to mailto:[email protected] with "unsubscribe neotek" in the message body. If you have any difficulties, or questions --please send an email to mailto:[email protected]. The Neotek list is lovingly hosted by Catapult Web. Remember that any message or reply sent to the list will be automatically forwarded to all subscribers. Vive Le Neotek! Thanks. ------ View the list online at: http://www.mail-archive.com/[email protected] You can unsubscribe at anytime by sending an email to mailto:[email protected] with "unsubscribe neotek" in the message body. If you have any difficulties, or questions --please send an email to mailto:[email protected]. The Neotek list is lovingly hosted by Catapult Web. Remember that any message or reply sent to the list will be automatically forwarded to all subscribers. Vive Le Neotek! Thanks.
