Re: NessusWX just stops

[Max]

Strange, I have the exact same configuration (except for XP instead of 2K) and I don't have any problems doing large scans. How do you communicate between your VMware host and Virtual machine ? I personally always setup a dedicated "host adapter" on eth1 and use that to communicate between NessusWX and nessusd. Nessusd uses eth0 to do its scan. According to your IP addresses below, you're scanning the same network 3 times. Shouldn't they be: 192.168.1.0/24 192.168.2.0/24 192.168.3.0/24 I put .0 here because that's the standard to specify a mask. I'm not sure if nessus is flexible in this matter. One last thing, what plugins do you have enabled ? Could one of them stop you somewhere ? Do a test by disabling all but a few plugins (no port scanners at this phase). -- Max Ott, Alexander wrote: Hi all, when I try to scan a subnetted network with 3 /24 subnets the scan stops after 32 IPs. I use the latest Nessus on suse 8.0 in VMWare and NessusWX on W2K. Target: 192.168.1.1/24 192.168.1.2/24 192.168.1.3/24 Max simultaneous: 16 Sec checks per host: 10 enable plugin dep: yes safe checks: yes optimize test: yes Resolve unknown services: yes Remove finished hosts from scan status view: yes Port range: 1-65535 Port Scanners acitvated: nmap, Ping remote host, LaBrea, SNMP port Scan, SYN Scan, tcp connect() scan All Plugins to be tried. I started this last night in order to be finished this morning. I would be thankful for any suggestions thx in advance Alex