Hi, everyone.
I implemented a private table(hnxWNetTable) using mib2c with
mib2c.mfd.conf.
When I readed the table contents using 'Table View'function of MG-Soft's
MIB Browser,
my subagent process was killed after responsing the requests normally.
_hnxWNetTable_initialize_interface function is as follows.
_hnxWNetTable_initialize_interface() in hnxWNetTable_interface.c
{
access_multiplexer->object_lookup = _mfd_hnxWNetTable_object_lookup;
access_multiplexer->get_values = _mfd_hnxWNetTable_get_values;
access_multiplexer->pre_request = _mfd_hnxWNetTable_pre_request;
access_multiplexer->post_request = _mdf_hnxWNetTable_post_request;
}
_mfd_hnxWNetTable_get_values() is worked successfully for first 'Table
View' request.
But after then, the subagent process is killed.
I don't know next operation after finishing access_multiplexer-
>get_values().
Could you tell me what points do I have to check?
------------------ Development Environment ----------------------
1. Net-snmp version : net-snmp 5.3.3
2. Table creation mib2c configuration : mib2c.mfd.conf
3. Private mib : implement private mib subagent with agentX protocol
---------------------------------------------------------------------------
------------------------------------------------------------------------------
This SF.net Dev2Dev email is sponsored by:
Show off your parallel programming skills.
Enter the Intel(R) Threading Challenge 2010.
http://p.sf.net/sfu/intel-thread-sfd
_______________________________________________
Net-snmp-users mailing list
Net-snmp-users@lists.sourceforge.net
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users
