In order to seed, you must explicitly set the network information -- you
need to assign network addresses to both networks:
en1 -seed -phase 2 -net XXX-XXX
en0 -seed -phase 2 -net YYY-YYY
You get to fill in XXX-XXX and YYY-YYY with whatever you want.
> I have posted a couple of times in the past and found no answer-
>
> I have 2 cards- eth0 (ne) which sees my internal network and eth1
> (3c509) which is outside.
>
> All I want is to route between the two interfaces. Running RH6.
>
> atalkd.conf started out as:
>
> en1 -seed
> en0 -seed
>
> (no zones are defined in either network)
>
> After starting netatalk:
>
> eth1 -seed -phase 2 -net 65280-65534 -addr 65280.70
> eth0 -seed -phase 2 -net 65280-65534 -addr 65280.253
>
> syslog says eth1 might not support multicast but of course it does-
>
> I can see my internal net, but nothing else. nbplkup sees the
> internal net but not the external.
>
> What am I doing wrong?
>
> -mab
>
