MLH wrote: > Jonathan A. Kollasch wrote: > > On Mon, Apr 29, 2024 at 02:16:13PM -0400, MLH wrote: > > > ifconfig : > > > re0: flags=0x8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 > > > > > > capabilities=0x3f80<TSO4,IP4CSUM_Rx,IP4CSUM_Tx,TCP4CSUM_Rx,TCP4CSUM_Tx> > > > capabilities=0x3f80<UDP4CSUM_Rx,UDP4CSUM_Tx> > > > enabled=0 > > > ec_capabilities=0x3<VLAN_MTU,VLAN_HWTAGGING> > > > ec_enabled=0 > > > address: (xx:xx:xx:xx:xx:xx) > > > media: Ethernet autoselect (1000baseT full-duplex) > > > status: active > > > inet6 (fe80::xxxx:xxxx:xxxx:xx%re0/64) flags 0 scopeid 0x1 > > > inet6 ::1000/128 flags 0 > > > > Has "::1000/128" been redacted? Because it looks bogus if it isn't. > > No. I didn't change that. > > I am using dhcpcd and maybe that isn't getting set up correctly > but --inform6 just returns with "sending commands to dhcpcd > process/send OK" and nothing else. I will try '--waitip=6' to > dhcpcd commands and see what happens there.
Same : inet6 fe80:: (redacted but looks good) inet6 ::1000/128 flags 0 dhcpcd issued a bunch of ipv6 stuff on startup that indicated all was fine but it didn't go into dmesg or a logfile that I can find and it appeared to wait a bit until an ipv6 addr was satisfied.
