If using UDP over VLAN, with the skge driver there is a possibility
of generating an incorrect checksum. This is a unlikely occurrence
because it is only an issue on Yukon revision 0, and that revision
doesn't seem to exist on any current hardware (probably early prototype).
Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]>
--- skge-2.6.orig/drivers/net/skge.c
+++ skge-2.6/drivers/net/skge.c
@@ -2300,14 +2300,12 @@ static int skge_xmit_frame(struct sk_buf
td->dma_hi = map >> 32;
if (skb->ip_summed == CHECKSUM_HW) {
- const struct iphdr *ip
- = (const struct iphdr *) (skb->data + ETH_HLEN);
int offset = skb->h.raw - skb->data;
/* This seems backwards, but it is what the sk98lin
* does. Looks like hardware is wrong?
*/
- if (ip->protocol == IPPROTO_UDP
+ if (skb->h.ipih->protocol == IPPROTO_UDP
&& hw->chip_rev == 0 && hw->chip_id == CHIP_ID_YUKON)
control = BMU_TCP_CHECK;
else
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
