From: Somnath Kotur <somnath.ko...@emulex.com> The Lancer FW has a bug due to which in some cases vlan-promisc setting is cleared eventhough the vlan-list programming did not succeed (via VLAN_CONFIG) cmd. The driver has no way of knowing if the vlan-promisc mode was cleared or not when this cmd fails. To work around this issue, this patch first explicitly clears the vlan-promisc mode via RX_FILTER cmd and then tries to program the vlan list. Signed-off-by: Somnath Kotur <somnath.ko...@emulex.com>
Signed-off-by: Sathya Perla <sathya.pe...@broadcom.com> --- drivers/net/ethernet/emulex/benet/be_main.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c index 1f16e73..2782299 100644 --- a/drivers/net/ethernet/emulex/benet/be_main.c +++ b/drivers/net/ethernet/emulex/benet/be_main.c @@ -1427,6 +1427,11 @@ static int be_vid_config(struct be_adapter *adapter) if (adapter->vlans_added > be_max_vlans(adapter)) return be_set_vlan_promisc(adapter); + if (adapter->if_flags & BE_IF_FLAGS_VLAN_PROMISCUOUS) { + status = be_clear_vlan_promisc(adapter); + if (status) + return status; + } /* Construct VLAN Table to give to HW */ for_each_set_bit(i, adapter->vids, VLAN_N_VID) vids[num++] = cpu_to_le16(i); @@ -1439,8 +1444,6 @@ static int be_vid_config(struct be_adapter *adapter) addl_status(status) == MCC_ADDL_STATUS_INSUFFICIENT_RESOURCES) return be_set_vlan_promisc(adapter); - } else if (adapter->if_flags & BE_IF_FLAGS_VLAN_PROMISCUOUS) { - status = be_clear_vlan_promisc(adapter); } return status; } -- 2.4.1