Hello!
On 12/04/2017 03:35 PM, Geert Uytterhoeven wrote:
From: Sergei Shtylyov <sergei.shtyl...@cogentembedded.com>
The PHY devices sometimes do have their reset signal (maybe even power
supply?) tied to some GPIO and sometimes it also does happen that a boot
loader does not leave it deasserted. So far this issue has been attacked
from (as I believe) a wrong angle: by teaching the MAC driver to manipulate
the GPIO in question; that solution, when applied to the device trees, led
to adding the PHY reset GPIO properties to the MAC device node, with one
exception: Cadence MACB driver which could handle the "reset-gpios" prop
in a PHY device subnode. I believe that the correct approach is to teach
the 'phylib' to get the MDIO device reset GPIO from the device tree node
corresponding to this device -- which this patch is doing...
Note that I had to modify the AT803x PHY driver as it would stop working
otherwise -- it made use of the reset GPIO for its own purposes...
Signed-off-by: Sergei Shtylyov <sergei.shtyl...@cogentembedded.com>
Acked-by: Rob Herring <r...@kernel.org>
[geert: Propagate actual errors from fwnode_get_named_gpiod()]
[geert: Avoid destroying initial setup]
[geert: Consolidate GPIO descriptor acquiring code]
Signed-off-by: Geert Uytterhoeven <geert+rene...@glider.be>
[...]
diff --git a/drivers/net/phy/mdio_bus.c b/drivers/net/phy/mdio_bus.c
index 2df7b62c1a36811e..8f8b7747c54bc478 100644
--- a/drivers/net/phy/mdio_bus.c
+++ b/drivers/net/phy/mdio_bus.c
[...]
@@ -48,9 +49,26 @@
int mdiobus_register_device(struct mdio_device *mdiodev)
{
+ struct gpio_desc *gpiod = NULL;
+
if (mdiodev->bus->mdio_map[mdiodev->addr])
return -EBUSY;
+ /* Deassert the optional reset signal */
Umm, but why deassert it here for such a short time?
+ if (mdiodev->dev.of_node)
+ gpiod = fwnode_get_named_gpiod(&mdiodev->dev.of_node->fwnode,
+ "reset-gpios", 0, GPIOD_OUT_LOW,
+ "PHY reset");
+ if (PTR_ERR(gpiod) == -ENOENT)
+ gpiod = NULL;
+ else if (IS_ERR(gpiod))
+ return PTR_ERR(gpiod);
Hm, returning on error with reset deasserted?
+
+ mdiodev->reset = gpiod;
+
+ /* Assert the reset signal again */
+ mdio_device_reset(mdiodev, 1);
+
mdiodev->bus->mdio_map[mdiodev->addr] = mdiodev;
return 0;
[...]
MBR, Sergei
