Hi Andrew,
For moment, I've only tested with PHY RGMII, RMII, MII, GMII, I do not have
other kind of PHY interface.
Normally there is no impact in my glue, the value of syscfg register will be
the same for RGMII/ID/TXID/RXID.
Do you think that I should add these interfaces in my case ?
case PHY_INTERFACE_MODE_RGMII:
> + case PHY_INTERFACE_MODE_RGMII_ID:
> + case PHY_INTERFACE_MODE_RGMII_RXID:
> + case PHY_INTERFACE_MODE_RGMII_TXID:
val = SYSCFG_PMCR_ETH_SEL_RGMII;
if (dwmac->int_phyclk)
val |= SYSCFG_PMCR_ETH_CLK_SEL;
pr_debug("SYSCFG init : PHY_INTERFACE_MODE_RGMII\n");
break;
Christophe.
-----Original Message-----
From: Andrew Lunn [mailto:[email protected]]
Sent: mardi 24 avril 2018 17:40
To: Christophe ROULLIER <[email protected]>
Cc: [email protected]; [email protected]; Alexandre TORGUE
<[email protected]>; Peppe CAVALLARO <[email protected]>;
[email protected]; [email protected];
[email protected]
Subject: Re: [PATCH 1/8] net: ethernet: stmmac: add adaptation for stm32mp157c.
On Tue, Apr 24, 2018 at 05:01:53PM +0200, Christophe Roullier wrote:
> + case PHY_INTERFACE_MODE_RGMII:
> + val = SYSCFG_PMCR_ETH_SEL_RGMII;
> + if (dwmac->int_phyclk)
> + val |= SYSCFG_PMCR_ETH_CLK_SEL;
> + pr_debug("SYSCFG init : PHY_INTERFACE_MODE_RGMII\n");
> + break;
Hi Christophe
What about PHY_INTERFACE_MODE_RGMII_ID, PHY_INTERFACE_MODE_RGMII_RXID and
PHY_INTERFACE_MODE_RGMII_TXID.
Andrew
