On Fri, 4 May 2018 10:01:38 +0100, Jose Abreu wrote:
> This adds support for U32 filter by using an HW only feature called
> Flexible RX Parser. This allow us to match any given packet field with a
> pattern and accept/reject or even route the packet to a specific DMA
> channel.
>
> Right now we only support acception or rejection of frame and we only
> support simple rules. Though, the Parser has the flexibility of jumping to
> specific rules as an if condition so complex rules can be established.
>
> This is only supported in GMAC5.10+.
>
> The following commands can be used to test this code:
>
> 1) Setup an ingress qdisk:
> # tc qdisc add dev eth0 handle ffff: ingress
>
> 2) Setup a filter (e.g. filter by IP):
> # tc filter add dev eth0 parent ffff: protocol ip u32 match ip \
> src 192.168.0.3 skip_sw action drop
>
> In every tests performed we always used the "skip_sw" flag to make sure
> only the RX Parser was involved.
>
> Signed-off-by: Jose Abreu <joab...@synopsys.com>
> Cc: David S. Miller <da...@davemloft.net>
> Cc: Joao Pinto <jpi...@synopsys.com>
> Cc: Vitor Soares <soa...@synopsys.com>
> Cc: Giuseppe Cavallaro <peppe.cavall...@st.com>
> Cc: Alexandre Torgue <alexandre.tor...@st.com>
> Cc: Jakub Kicinski <kubak...@wp.pl>
> ---
> Changes from v1:
> - Follow Linux network coding style (David)
> - Use tc_cls_can_offload_and_chain0() (Jakub)
Thanks!
> @@ -4223,6 +4277,11 @@ int stmmac_dvr_probe(struct device *device,
> ndev->hw_features = NETIF_F_SG | NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM |
> NETIF_F_RXCSUM;
>
> + ret = stmmac_tc_init(priv, priv);
> + if (!ret) {
> + ndev->hw_features |= NETIF_F_HW_TC;
> + }
> +
> if ((priv->plat->tso_en) && (priv->dma_cap.tsoen)) {
> ndev->hw_features |= NETIF_F_TSO | NETIF_F_TSO6;
> priv->tso = true;
One more comment, but perhaps not a showstopper, it's considered good
practice to disallow clearing/disabling this flag while filters are
installed. Driver should return -EBUSY from .ndo_set_features if TC
rules are offloaded and user wants to disable HW_TC feature flag.
