[PATCH 2/2] arm64: dts: clearfog-gt-8k: 1G eth PHY reset signal

[Baruch Siach]

This reset signal controls the Marvell 1512 1G PHY.

Note that current implementation queries the PHY over the MDIO bus
(get_phy_device() call from of_mdiobus_register_phy()) before reset
signal deassert. If the PHY reset signal is asserted at boot time, PHY
registration fails. So current code relies on the bootloader to deassert
the reset signal.

Signed-off-by: Baruch Siach <bar...@tkos.co.il>
---
 arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts 
b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
index af1310c53bc8..73df0ef5e0c4 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
@@ -337,6 +337,10 @@
                 */
                marvell,reg-init = <3 16 0 0x1017>;
                reg = <0>;
+               pinctrl-names = "default";
+               pinctrl-0 = <&cp0_copper_eth_phy_reset>;
+               reset-gpios = <&cp1_gpio1 11 GPIO_ACTIVE_LOW>;
+               reset-assert-us = <10000>;
        };
 
        switch0: switch0@4 {
-- 
2.19.1