Quoting Michael Buesch <[EMAIL PROTECTED]>: > Ok, nice. > Can you send me a complete dmesg log after you brought up the card > and tried to assoc/send some packets?
Attached. -- Regards, Pavel Roskin
ACPI: PCI Interrupt 0000:0c:00.0[A] -> GSI 17 (level, low) -> IRQ 17 PCI: Setting latency timer of device 0000:0c:00.0 to 64 ssb: Sonics Silicon Backplane found on PCI device 0000:0c:00.0 ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x11, vendor 0x4243) ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x0A, vendor 0x4243) ssb: Core 2 found: USB 1.1 Host (cc 0x817, rev 0x03, vendor 0x4243) ssb: Core 3 found: PCI-E (cc 0x820, rev 0x01, vendor 0x4243) ssb: Switching to ChipCommon core, index 0 ssb: Switching to PCI-E core, index 3 ssb: PCIcore in client mode found wmaster0: Selected rate control algorithm 'simple' ssb: Switching to IEEE 802.11 core, index 1 ssb: Switching to PCI-E core, index 3 ssb: Switching to IEEE 802.11 core, index 1 bcm43xx_d80211: Adding Interface type 2 bcm43xx_d80211: Found PHY: Version 4, Type 2, Revision 8 bcm43xx_d80211: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2 bcm43xx_d80211: Loading firmware version 351.126 (2006-07-29 05:54:02) ssb: Switching to ChipCommon core, index 0 ssb: Switching to IEEE 802.11 core, index 1 bcm43xx_d80211: Radio turned on bcm43xx_d80211: FIXME: Possibly broken code in bcm43xx_phy_initg() at drivers/net/wireless/d80211/bcm43xx/bcm43xx_phy.c:1650 bcm43xx_d80211: Chip initialized bcm43xx_d80211: 32-bit DMA initialized bcm43xx_d80211: Wireless interface started wmaster0: Does not support passive scan, disabled wlan0: starting scan wlan0: scan completed bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: Initial auth_alg=0 wlan0: authenticate with AP 00:0f:66:2f:ef:59 wlan0: authenticate with AP 00:0f:66:2f:ef:59 wlan0: authenticate with AP 00:0f:66:2f:ef:59 wlan0: authentication with AP 00:0f:66:2f:ef:59 timed out bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: starting scan wlan0: scan completed bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: starting scan wlan0: scan completed bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: starting scan bcm43xx_d80211: Wireless interface stopped bcm43xx_d80211: Removing Interface type 2 bcm43xx_d80211: DMA-32 0x0200 (RX) max used slots: 1/64 bcm43xx_d80211: DMA-32 0x02A0 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0280 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0260 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0240 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0220 (TX) max used slots: 2/128 bcm43xx_d80211: DMA-32 0x0200 (TX) max used slots: 0/128 bcm43xx_d80211: Radio turned off ssb: Switching to ChipCommon core, index 0 bcm43xx_d80211: Adding Interface type 2 ssb: Switching to IEEE 802.11 core, index 1 bcm43xx_d80211: Found PHY: Version 4, Type 2, Revision 8 bcm43xx_d80211: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2 bcm43xx_d80211: Loading firmware version 351.126 (2006-07-29 05:54:02) ssb: Switching to ChipCommon core, index 0 ssb: Switching to IEEE 802.11 core, index 1 bcm43xx_d80211: Radio turned on bcm43xx_d80211: FIXME: Possibly broken code in bcm43xx_phy_initg() at drivers/net/wireless/d80211/bcm43xx/bcm43xx_phy.c:1650 bcm43xx_d80211: Chip initialized bcm43xx_d80211: 32-bit DMA initialized bcm43xx_d80211: Wireless interface started wmaster0: Does not support passive scan, disabled bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: starting scan wlan0: scan completed bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: starting scan wlan0: scan completed bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: Initial auth_alg=0 wlan0: authenticate with AP 00:0f:66:2f:ef:59 wlan0: authenticate with AP 00:0f:66:2f:ef:59 wlan0: authenticate with AP 00:0f:66:2f:ef:59 wlan0: authentication with AP 00:0f:66:2f:ef:59 timed out bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff wlan0: starting scan wlan0: scan completed bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff bcm43xx_d80211: Wireless interface stopped bcm43xx_d80211: Removing Interface type 2 bcm43xx_d80211: DMA-32 0x0200 (RX) max used slots: 1/64 bcm43xx_d80211: DMA-32 0x02A0 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0280 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0260 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0240 (TX) max used slots: 0/128 bcm43xx_d80211: DMA-32 0x0220 (TX) max used slots: 2/128 bcm43xx_d80211: DMA-32 0x0200 (TX) max used slots: 0/128 bcm43xx_d80211: Radio turned off ssb: Switching to ChipCommon core, index 0
# ./wpa_supplicant -D wext -i wlan0 -c JEDI3.conf ioctl[SIOCSIWAUTH]: Operation not supported WEXT auth param 4 value 0x0 - ioctl[SIOCSIWAUTH]: Operation not supported WEXT auth param 5 value 0x1 - Trying to associate with 00:0f:66:2f:ef:59 (SSID='JEDI' freq=2437 MHz) ioctl[SIOCSIWAUTH]: Operation not supported WEXT auth param 5 value 0x1 - ioctl[SIOCSIWMODE]: Device or resource busy Association request to the driver failed Authentication with 00:00:00:00:00:00 timed out. Trying to associate with 00:0f:66:2f:ef:59 (SSID='JEDI' freq=2437 MHz) ioctl[SIOCSIWAUTH]: Operation not supported WEXT auth param 5 value 0x1 - ioctl[SIOCSIWMODE]: Device or resource busy Association request to the driver failed Authentication with 00:00:00:00:00:00 timed out. Trying to associate with 00:0f:66:2f:ef:59 (SSID='JEDI' freq=2437 MHz) ioctl[SIOCSIWAUTH]: Operation not supported WEXT auth param 5 value 0x1 - ioctl[SIOCSIWMODE]: Device or resource busy Association request to the driver failed Authentication with 00:00:00:00:00:00 timed out. CTRL-EVENT-TERMINATING - signal 2 received ioctl[SIOCSIWAUTH]: Operation not supported WEXT auth param 5 value 0x0 - ioctl[SIOCSIWAUTH]: Operation not supported
