On Thu, 01 Mar 2007, Ben Greear wrote:
> Ben Greear wrote:
>
> I am sending udp packets through ppp400, and I see them appear on ppp401
> as expected.
>
> The thing that is bothering me is that all I see on rddVR4 (172.1.2.1)
> is arps for 172.1.2.2, but the 'tell' IP is that of the
> originating ppp400 link, not the IP of rddVR4, as I expected:
>
> 21:47:16.119640 arp who-has 172.1.2.2 tell 11.1.1.3
> 21:47:17.119371 arp who-has 172.1.2.2 tell 11.1.1.3
> 21:47:18.119254 arp who-has 172.1.2.2 tell 11.1.1.3
> 21:47:19.273118 arp who-has 172.1.2.2 tell 11.1.1.3
>
> Unless I'm missing something dumb, a similar setup with all ethernet-ish
> network devices
> works fine.
>
> I have also enabled arp filtering:
> # Only answer ARPs if it is for the IP on our own interface.
> echo 2 > /proc/sys/net/ipv4/conf/all/arp_ignore
> and for every device used in these routing tables:
> echo 1 > /proc/sys/net/ipv4/conf/[dev]/arp_filter
>
> Any idea what I need to do in order to make the source IP for the ARP
> packet correct?
Wouldn't that be controlled by arp_announce?
arp_announce - INTEGER
Define different restriction levels for announcing the local
source IP address from IP packets in ARP requests sent on
interface:
0 - (default) Use any local address, configured on any interface
1 - Try to avoid local addresses that are not in the target's
subnet for this interface. This mode is useful when target
hosts reachable via this interface require the source IP
address in ARP requests to be part of their logical network
configured on the receiving interface. When we generate the
request we will check all our subnets that include the
target IP and will preserve the source address if it is from
such subnet. If there is no such subnet we select source
address according to the rules for level 2.
2 - Always use the best local address for this target.
In this mode we ignore the source address in the IP packet
and try to select local address that we prefer for talks with
the target host. Such local address is selected by looking
for primary IP addresses on all our subnets on the outgoing
interface that include the target IP address. If no suitable
local address is found we select the first local address
we have on the outgoing interface or on all other interfaces,
with the hope we will receive reply for our request and
even sometimes no matter the source IP address we announce.
The max value from conf/{all,interface}/arp_announce is used.
Increasing the restriction level gives more chance for
receiving answer from the resolved target while decreasing
the level announces more valid sender's information.
-Bill
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
