When 88E111 is operating in SGMII mode, auto-negotiation should be enabled
on the SGMII side so that the link will come up properly with PCSes which
normally have auto-negotiation enabled. This is normally the case when the
PHY defaults to SGMII mode at power-up, however if we switched it from some
other mode like 1000BaseX, as may happen in some SFP module situations,
it may not be.
Call genphy_check_and_restart_aneg on the fiber page to ensure that auto-
negotiation is properly enabled on the SGMII interface.
Signed-off-by: Robert Hancock <robert.hanc...@calian.com>
---
drivers/net/phy/marvell.c | 13 ++++++++-----
1 file changed, 8 insertions(+), 5 deletions(-)
diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
index 3238d0fbf437..e26a5d663f8a 100644
--- a/drivers/net/phy/marvell.c
+++ b/drivers/net/phy/marvell.c
@@ -684,16 +684,19 @@ static int m88e1111_config_aneg(struct phy_device *phydev)
if (err < 0)
goto error;
- /* Do not touch the fiber page if we're in copper->sgmii mode */
- if (phydev->interface == PHY_INTERFACE_MODE_SGMII)
- return 0;
-
/* Then the fiber link */
err = marvell_set_page(phydev, MII_MARVELL_FIBER_PAGE);
if (err < 0)
goto error;
- err = marvell_config_aneg_fiber(phydev);
+ if (phydev->interface == PHY_INTERFACE_MODE_SGMII)
+ /* Do not touch the fiber advertisement if we're in
copper->sgmii mode.
+ * Just ensure that SGMII-side autonegotiation is enabled.
+ * If we switched from some other mode to SGMII it may not be.
+ */
+ err = genphy_check_and_restart_aneg(phydev, false);
+ else
+ err = marvell_config_aneg_fiber(phydev);
if (err < 0)
goto error;
--
2.27.0
