On Wed, Oct 03, 2007 at 01:46:16PM -0400, Jeff Garzik wrote: > Olof Johansson wrote: >> pasemi_mac: clear out old errors on interface open >> Clear out any pending errors when an interface is brought up. Since the >> bits >> are sticky, they might be from interface shutdown time after firmware has >> used it, etc. >> Signed-off-by: Olof Johansson <[EMAIL PROTECTED]> > > In general, interface-open should completely reset and initialize the > hardware. does pasemi_mac not do that?
There's no explicit way to reset just one interface besides disabling it (which we do at close, and re-enable at open). It seems that some of the error bits are sticky across disable/enable, which is why this was needed. Also, they're RW1C, so writing 0 doesn't remove them (need to write 1 to clear). The only other dependency from firmware at this time is the setting of mac addresses, something that will be taken care of once we allow override of them via ethtool, since we'd need to program them from the driver then no matter what. Right now we assume that firmware has programmed it. -Olof - To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
