Andrew Lunn <and...@lunn.ch> writes: > So the ports look like normal ports, and you configure then using the > normal mechanisms. > > DSA does not use vlans. It uses an additional protocol header which > the switch supports, to allow the CPU to direct packets out a specific > port. Similarly, packets coming to the CPU from a port and marked with > the port they ingressed. This means the ports are completely separated > by default. When you add interfaces to a bridge, calls are made by the > bridge code into DSA to setup the switch to hardware bridge the > interface. And if the switch driver does not support it, software > bridging is used instead. Unless you know what is going on under the > hood, you have no idea that eth0 and eth1 are used to carry packets to > the switch, and that the switch is bridging the interfaces. So it is > linux concepts, with some hardware acceleration.
Thanks a lot. This filled most of the blank spots. I should have done some research into what dsa actually is before posting my question. > Now back to you question. What is clearly hardware and needs to go > into device tree is the mapping between switch ports and cpu > ports. eth0 <--> port 6, eth1 <--> port 5. > > But i've reconsidered putting into device tree the load balancing of > which slave ports, lan[1-4], wan, are attached to which master port, > eth[01]. It should not be in DT. We want a sensible default, which i > would say is what i had in DT, allocate them every other, but > implement this in software. And allow the user to move slaves between > masters, using a user space command. Something like: > > ip link set dev lan4 master eth0 > > So if you wish, you can then have eth1 dedicated to WAN, and eth0 for > lan[1-4]. Or any other combination. > > I would say implementing this command to move a slave between masters > can come later, so long as we have a default which works for most > people. Using every other is clearly between than only using one > interface. Yes, that sounds reasonable. But I do still wonder if this model can be made flexible enough. How about a switch having more CPU ports than external ports (just an imaginary product - I don't know if anyone is crazy enough to make it)? Or what if I'd like to dedicate CPU port eth0 to VLAN 13, while CPU port eth1 handles everything else? With lan0 carrying an 802.1q trunk with both VLAN 13 and more, i.e. a mix of packets for both eth0 and eth1? Well, I'm being difficult now :) We can probably do fine without being able to express those things. And I realize that I'm a bit too late into any discussion about modelling this. Thanks again for taking the time to write such a good answer. Bjørn -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
