Tantilov, Emil S <emil.s.tanti...@intel.com> wrote:
>We are seeing an occasional issue where the bonding driver may report
>interface up with 0 Mbps:
>bond0: link status definitely up for interface eth0, 0 Mbps full duplex
>
>So far in all the failed traces I have collected this happens on
>NETDEV_CHANGELOWERSTATE event:
>
><...>-20533 [000] .... 81811.041241: ixgbe_service_task: eth1: NIC Link is Up
>10 Gbps, Flow Control: RX/TX
><...>-20533 [000] .... 81811.041257: ixgbe_check_vf_rate_limit
><-ixgbe_service_task
><...>-20533 [000] .... 81811.041272: ixgbe_ping_all_vfs <-ixgbe_service_task
>kworker/u48:0-7503 [010] .... 81811.041345: ixgbe_get_stats64 <-dev_get_stats
>kworker/u48:0-7503 [010] .... 81811.041393: bond_netdev_event: eth1: event: 1b
>kworker/u48:0-7503 [010] .... 81811.041394: bond_netdev_event: eth1: IFF_SLAVE
>kworker/u48:0-7503 [010] .... 81811.041395: bond_netdev_event: eth1:
>slave->speed = ffffffff
><...>-20533 [000] .... 81811.041407: ixgbe_ptp_overflow_check
><-ixgbe_service_task
>kworker/u48:0-7503 [010] .... 81811.041407: bond_mii_monitor: bond0: link
>status definitely up for interface eth1, 0 Mbps full duplex
Thinking about the trace again... Emil: what happens in the
trace before this? Is there ever a call to the ixgbe_get_settings?
Does a NETDEV_UP or NETDEV_CHANGE event ever hit the bond_netdev_event
function?
Could you describe your test that reproduces this? I'd like to
see if I can set it up locally.
-J
---
-Jay Vosburgh, jay.vosbu...@canonical.com
