On Sat, Nov 17, 2018 at 09:19:52PM +0900, Xin Long wrote: > On Sat, Nov 17, 2018 at 8:15 PM Pablo Neira Ayuso <pa...@netfilter.org> wrote: > > > > On Fri, Nov 16, 2018 at 06:37:19AM -0800, Simon Horman wrote: > > > On Fri, Nov 16, 2018 at 09:10:16AM +0200, Julian Anastasov wrote: > > > > > > > > Hello, > > > > > > > > On Thu, 15 Nov 2018, Xin Long wrote: > > > > > > > > > ip_vs_dst_event is supposed to clean up all dst used in ipvs' > > > > > destinations when a net dev is going down. But it works only > > > > > when the dst's dev is the same as the dev from the event. > > > > > > > > > > Now with the same priority but late registration, > > > > > ip_vs_dst_notifier is always called later than ipv6_dev_notf > > > > > where the dst's dev is set to lo for NETDEV_DOWN event. > > > > > > > > > > As the dst's dev lo is not the same as the dev from the event > > > > > in ip_vs_dst_event, ip_vs_dst_notifier doesn't actually work. > > > > > Also as these dst have to wait for dest_trash_timer to clean > > > > > them up. It would cause some non-permanent kernel warnings: > > > > > > > > > > unregister_netdevice: waiting for br0 to become free. Usage count = > > > > > 3 > > > > > > > > > > To fix it, call ip_vs_dst_notifier earlier than ipv6_dev_notf > > > > > by increasing its priority to ADDRCONF_NOTIFY_PRIORITY + 5. > > > > > > > > > > Note that for ipv4 route fib_netdev_notifier doesn't set dst's > > > > > dev to lo in NETDEV_DOWN event, so this fix is only needed when > > > > > IP_VS_IPV6 is defined. > > > > > > > > > > v1->v2: > > > > > - apply it only when CONFIG_IP_VS_IPV6 is defined. > > > > > > > > > > Fixes: 7a4f0761fce3 ("IPVS: init and cleanup restructuring") > > > > > Reported-by: Li Shuang <shu...@redhat.com> > > > > > Signed-off-by: Xin Long <lucien....@gmail.com> > > > > > > > > Acked-by: Julian Anastasov <j...@ssi.bg> > > > > > > Thanks, > > > > > > Pablo, could you consider this for nf? > > > > > > Acked-by: Simon Horman <ho...@verge.net.au> > > > > Applied, thanks Simon. > Hi Pablo, > > The one you just applied is the v1, I'm afraid you need > to revert and apply the v2, which fixed a build error > when IPv6 is disabled.
Fixed, thanks!