Hi Tarek,
This works for me. 
Thanks,
Acee

On 8/14/20, 12:25 PM, "Tarek Saad" <ts...@juniper.net> wrote:

    Hi Acee and Tom,

    The authors of ID: draft-ietf-mpls-base-yang met and we discussed the 
points below.
    We understand that RFC8349 defines an AF-agnostic model for RIBs. RFC8349 
defined only two types of RIBs (IPv4 and IPv6 RIBs), but we envision other 
types of RIBs too (e.g. L2 RIB, MCAST RIB, etc.), in addition to MPLS RIB -- 
and we hope all such RIBs indeed leverage the generic RIB model introduced in 
RFC8349.

    We revisited Acee's suggestion and made a small modification (on top of it) 
that makes IP routes, MPLS routes (and possibly L2 or MCAST routes in future) - 
all have similar MPLS augmentation (in terms of local-label) while still 
adhering with RFC8349 to augment with leaf destination-prefix.

    augment "/rt:routing/rt:ribs/rt:rib/rt:routes/rt:route" {
      when "derived-from-or-self(../../rt:address-family, "
         + "'mpls:mpls')" {
        description
          "This augment is valid only for native MPLS routes.";
      }
      description
        "This leaf augments a native MPLS route.";
      leaf destination-prefix {
        type leafref {
          path "../local-label";
        }
        description
          "MPLS destination prefix.";
      }
    }

    We follow same approach for the active route RPC and continue to use a leaf 
"destination-address" as input (that points to a local-label leaf).
    If this is acceptable, we believe the errata 6251 can be rejected and we'll 
proceed with the change in the MPLS RIB model.

    Regards,
    Tarek (for authors)

    On 8/11/20, 9:08 AM, "Acee Lindem (acee)" <a...@cisco.com> wrote:

        [External Email. Be cautious of content]


        Hi Tom, Draft Authors,

        The draft could easily be fixed. You just need to:

          1. Expand on the single sentence in section 2.1 on the need for 
non-IP MPLS routes. Given that the draft wasn't modeled correctly, this wasn't 
apparent to most of the reviewers.
          2. Add an MPLS AF only augmentation (enforced via a when statement) 
to each route for the MPLS AF specific destination-prefix or 
destination-address.
          3. Limit the current local-label augmentation to non-MPLS AFs.
          4. Limit the active-route augmentation to AF MPLS and change the 
input to destination-address.

        Thanks,
        Acee

        On 8/11/20, 6:10 AM, "tom petch" <ie...@btconnect.com> wrote:

            From: Acee Lindem (acee) <a...@cisco.com>
            Sent: 11 August 2020 10:47

            Hi Tom,
            I fully understood your original comment. There are other problems 
with this model. See inline.

            On 8/11/20, 4:59 AM, "tom petch" <ie...@btconnect.com> wrote:

                Tarek

                Picking up on an earlier point,

                ________________________________________
                From: Tarek Saad <ts...@juniper.net>
                Sent: 10 August 2020 21:23

                Hi Acee,

                The existing RPC is used to query (defined AFIs=IPv4/IPv6) RIB 
to return the matching active route identified by a "destination address".
                The MPLS module is trying to reuse this RPC so to query the 
MPLS RIB to return the matching active route identified by a "local label".
                The RPC defined in RFC 8349 readily accepts MPLS AFI in it 
(/rt:routing/rt:ribs/rt:rib/rt:active-route) - unless we augment and suppress 
it with a "when check".
                IMO, it is reusable as-is but the text below is limiting the 
leaf name that identifies an entry in RIB to "destination-address" only - in 
MPLS RIB the entry leaf name that identifies an entry is "local-label".

            It is not reusable as is since the augmentation RPC augmentation 
must have a when statement restricting it to AF MPLS. Also, local-label is a 
leaf which is applicable to all address families. It cannot be the AF MPLS 
destination-prefix. This augmentation is missing.

            <tp>
            I am probably getting out of my depth here,  On 1may20 I raised the 
issue of why the 'MUST' in the description in RFC8349 was not enforced in the 
YANG and 5may20 Martin explained that there is a rule in the YANG ABNF of 
input-stmt that makes the obvious impossible:-(  You are raising more profound 
issues about the RIB that I had not perceived when I reviewed mpls-base-yang 
for which I, and I hope everyone else, will be grateful.

            If this mpls I-D is to proceed in the immediate future, it looks 
like the action may have to be deferred for future study.

            More generally, I think that the interaction of forward by address 
and forward by label is challenging.  When first I looked at the MPLS I-D I was 
surprised at the way RFC8349 was augmented.  I had not seen MPLS as an 
alternative to IPv4 or IPv6 or ... in the way in which the RFC is used although 
the RFC does state that it can be; rather, to me, labels are a different 
animal, but I assumed that everyone knew what they were doing.

            Tom Petch


            Thanks,
            Acee


                <tp>
                There should be a 'when' check to enforce the 'MUST' but the 
rules of YANG do not allow it in this structure.  I raised this on the NETMOD 
list at the time of WGLC and Martin pointed me to a rule in the ABNF which 
prohibits such a check.  He also said that the rule was not needed and would be 
a candidate to remove when YANG is revised.

                Hence I have always thought of this MUST in the documentation 
as a constraint that must be enforced in the YANG

                Tom Petch
                        >            action active-route {
                        >              description
                        >                "Return the active RIB route that is 
used for the
                        >                 destination address.
                        >
                        >                 Address-family-specific modules MUST 
augment input
                        >                 parameters with a leaf named 
'destination-address'.";

                Regards,
                Tarek

                On 8/10/20, 3:27 PM, "Acee Lindem (acee)" <a...@cisco.com> 
wrote:

                    [External Email. Be cautious of content]


                    All (Speaking as an author of RFC 8349),
                    I just looked at this in more detail and I don't think the 
ietf-mpls.yang model should be augmenting the 
/rt:routing/rt:ribs/rt:rib/rt:active-route RPC. The intent of the RPC is to 
return the address-family specific active-route corresponding to the 
destination-address. This model attempts to overload this RPC with a different 
action all together - returning a route that has the local-label as an optional 
attribute. I'd reject the Errata and believe the augmentation should be removed 
from ietf-mpl.yang. Whether it is replaced with a different one is up to the 
co-authors of ietf-mpls.yang.
                    Thanks,
                    Acee

                    On 8/10/20, 2:29 PM, "Rob Wilton (rwilton)" 
<rwil...@cisco.com> wrote:

                        [Resend to hopefully pass recipient limit filter]

                        Hi Tom,

                        I would be interested to hear from the original authors.

                        My impression is that this is a technically reasonable 
change, but I don't think that an erratum can create a new revision of a YANG 
module.

                        If this erratum was processed as "Hold for document 
update" then would that be sufficient to do the right thing in the MPLS YANG 
module?

                        Regards,
                        Rob


                        > -----Original Message-----
                        > From: tom petch <ie...@btconnect.com>
                        > Sent: 10 August 2020 17:32
                        > To: RFC Errata System <rfc-edi...@rfc-editor.org>; 
lho...@nic.cz; Acee
                        > Lindem (acee) <a...@cisco.com>; 
yingzhen...@huawei.com; war...@kumari.net;
                        > Rob Wilton (rwilton) <rwil...@cisco.com>; 
joe...@bogus.com;
                        > kent+i...@watsen.net; lber...@labn.net
                        > Cc: ts...@juniper.net; netmod@ietf.org
                        > Subject: Re: [netmod] [Technical Errata Reported] 
RFC8349 (6251)
                        >
                        > From: netmod <netmod-boun...@ietf.org> on behalf of 
RFC Errata System
                        > <rfc-edi...@rfc-editor.org>
                        > Sent: 07 August 2020 16:45
                        >
                        > <tp>
                        > This is the erratum of whose arrival I speculated on 
this list on June
                        > 16th.
                        >
                        > There is a degree of urgency about it.  The I-D in 
question is mpls-base-
                        > yang, currently in IETF Last Call, which is a 
Normative dependency of bfd-
                        > yang which is a Normative dependency for a small 
mountain of I-D which
                        > have been waiting a year or so (e.g.  ospf-yang).
                        >
                        > I suspect that the technically perfect solution would 
involve a YANG
                        > union, choice or some such structure but as I said in 
my Last Call comment
                        > I can live with a label that contains such as 
'address' encompassing such
                        > as 'label' in the context of forwarding.  I take 
labels to mean what
                        > labels mean rather than what I might find in a work 
of reference.
                        >
                        > Tom Petch
                        >
                        > The following errata report has been submitted for 
RFC8349,
                        > "A YANG Data Model for Routing Management (NMDA 
Version)".
                        >
                        > --------------------------------------
                        > You may review the report below and at:
                        > 
https://urldefense.com/v3/__https://www.rfc-editor.org/errata/eid6251__;!!NEt6yMaO-gk!URK5WVsqD5g7WpzCU1VuzKJA0AUiawXBFLB_gENlsYMrpiMqDtyFoxw8DnSr2A$
                        >
                        > --------------------------------------
                        > Type: Technical
                        > Reported by: Tarek Saad <ts...@juniper.net>
                        >
                        > Section: 7
                        >
                        > Original Text
                        > -------------
                        > The RPC "active-route" is used to retrieve the active 
route in a RIB.
                        > RFC8349 defined two AFIs (v4/v6).
                        >
                        > draft-ietf-mpls-base-yang is defining a new RIB AFI 
for MPLS as per
                        > section 3 in RFC8349.
                        >
                        > The RPC has a "MUST" statement that all RIBs must 
augment input
                        > parameters with a leaf named 'destination-address'.
                        >
                        > For MPLS RIB, it makes sense to augment with leaf 
named 'local-label'
                        > since MPLS routes are identified by MPLS label.
                        >
                        > We ask to make the following change:
                        >
                        > OLD:
                        >            action active-route {
                        >              description
                        >                "Return the active RIB route that is 
used for the
                        >                 destination address.
                        >
                        >                 Address-family-specific modules MUST 
augment input
                        >                 parameters with a leaf named 
'destination-address'.";
                        >
                        >
                        > Corrected Text
                        > --------------
                        > NEW:
                        >            action active-route {
                        >              description
                        >                "Return the active RIB route that is 
used for the
                        >                 destination address.
                        >
                        >                 Address-family-specific modules MUST 
augment input
                        >                 parameters with a suitable leaf that 
identifies the
                        > route.";
                        >
                        >
                        > Notes
                        > -----
                        >
                        >
                        > Instructions:
                        > -------------
                        > This erratum is currently posted as "Reported". If 
necessary, please
                        > use "Reply All" to discuss whether it should be 
verified or
                        > rejected. When a decision is reached, the verifying 
party
                        > can log in to change the status and edit the report, 
if necessary.
                        >
                        > --------------------------------------
                        > RFC8349 (draft-ietf-netmod-rfc8022bis-11)
                        > --------------------------------------
                        > Title               : A YANG Data Model for Routing 
Management (NMDA
                        > Version)
                        > Publication Date    : March 2018
                        > Author(s)           : L. Lhotka, A. Lindem, Y. Qu
                        > Category            : PROPOSED STANDARD
                        > Source              : Network Modeling
                        > Area                : Operations and Management
                        > Stream              : IETF
                        > Verifying Party     : IESG
                        >
                        > _______________________________________________
                        > netmod mailing list
                        > netmod@ietf.org
                        > 
https://urldefense.com/v3/__https://www.ietf.org/mailman/listinfo/netmod__;!!NEt6yMaO-gk!URK5WVsqD5g7WpzCU1VuzKJA0AUiawXBFLB_gENlsYMrpiMqDtyFoxxyc2_LZA$



                Juniper Business Use Only



        Juniper Business Use Only


    Juniper Business Use Only

_______________________________________________
netmod mailing list
netmod@ietf.org
https://www.ietf.org/mailman/listinfo/netmod

Reply via email to