On Fri, Dec 26, 2008 at 01:09:59AM +0100, <Francesco Cat>:
~> I have managed to get Netsukuku running in Virtual Box and I wanted to try
~> out some basic stuff, but I had no succes. Is there any HowTo /
~> Documentation about using Netsukuku with "standard" programs? EG: ping.
no, there isn't, because no one has still tested pyntk. You are the first. You
can document what you're doing.
Launch pyntk in the two nodes, then
try to use the following commands to see if everything is ok:
route -n
ip route list
ip link list
ip neigh list
"ok" means that the two nodes have an IP and that there are good routes to
reach each other. If in doubt, paste here in the ml.
If everything is ok, then get their IPs from the commands above, and use
ping/ssh/whatever.
~> Moreover, I was not able to understand if ANDNA in currently implemented in
~> pyntk and if there is doc about it too.
no, it's not implemented. P2P_over_ntk is implemented and it is the core where
ANDNA should stand.
Note also that Eriol cleaned the code
http://dev.hinezumi.org/svnroot/netsukuku/branches/networking-abstraction/
but it isn't still merged in the trunk.
So you should take a look at it.
Anyway, the best thing to do is:
1) document what you are doing
2) debug and test. try to see if everything is "ok":
a) the radar works: the two nodes see each other
b) routes are set correctly
3) try to add more than two nodes
--
:wq!
"I don't know nothing" The One Who reached the Thinking Matter '.'
[ Alpt --- Freaknet Medialab ]
[ GPG Key ID 441CF0EE ]
[ Key fingerprint = 8B02 26E8 831A 7BB9 81A9 5277 BFF8 037E 441C F0EE ]
_______________________________________________
Netsukuku mailing list
[email protected]
http://lists.dyne.org/mailman/listinfo/netsukuku
