Hi Dave, That was it. Dumb mistake. Thank you.
-J On 2/28/07, Dave <[EMAIL PROTECTED]> wrote:
Jason, The interfaces should be unplumbed when you create the aggregation with dladm: ifconfig e1000g0 unplumb ifconfig e1000g1 unplumb dladm create-aggr -d e1000g0 -d e1000g1 5 --Dave Jason J. W. Williams wrote: > Hi Sebastien, > > I'll have to take a look at dhcpagent. Wasn't involved in the actual > install process...I think my dev installed it with the Dev. Edition of > SX-CR. Playing with ifconfig I did completely unplumb and then > replumb (no IP address) the interfaces. Also, tried > unplumbing->modunload->modload->plumb. To no avail. dhcpagent is a > promising idea though. Thank you! > > Best Regards, > Jason > > On 2/28/07, Sebastien Roy <[EMAIL PROTECTED]> wrote: >> Jason J. W. Williams wrote: >> > I loaded Build 57 clean on a new X4600 and am having issues creating >> > link aggregations. Its acting as if the e1000g driver is not GLDv3 >> > compatible: "dladm: create operation failed: Device busy (invalid >> > interface name)" >> >> This message is printed if one of the devices you're adding to the >> aggregation has IP plumbed on it, or is in use by dhcpagent. The >> message is misleading, and lacking in specifics. Make sure none of the >> links in your aggregation are in use before creating the aggregation. >> >> -Seb >> > _______________________________________________ > networking-discuss mailing list > [email protected] _______________________________________________ networking-discuss mailing list [email protected]
_______________________________________________ networking-discuss mailing list [email protected]
