Sebastien Roy wrote:
On Fri, 2009-06-05 at 14:49 +0300, Stoyan Angelov wrote:
i am trying to configure several zones as ipv6-only hosts. i do not want
to have the ipv4 stack enabled at all.
There is not a separate "stack" for IPv4 and IPv6. It is one networking
stack, and IPv4 or IPv6 is used depending on the interfaces and
addresses configured.
i have been using dual-stack
configuration for a long time but now i want to have pure ipv6 machine.
is this possible ?
Yes, simply don't configure any IPv4 addresses. Note that you should
keep the IPv4 loopback address, as local applications may depend on
being able to use it.
hi Sebastien,
i have configured the zones in question that way, however i thought the
ipv4 loopback address could be removed.
also the interactive installer refuses to continue if you don't specify
a correct ipv4 address. should this be considered a bug ?
greetings,
Stoyan
_______________________________________________
networking-discuss mailing list
[email protected]
