Hi, I have an FC5 laptop with a Proxim wireless card. I installed the madwifi 0.9.0 drivers with wpa_supplicant version wpa_supplicant-0.4.8-10.fc5.
My access point is using wpa encryption. If I configure wpa_supplicant manually everything works OK. The problem is that nm does not see the wireless card at all. As a result if I am on a wired network and try to switch to wireless things do not get setup properly. Routes etc. need to be added by hand or I need to reboot. As I am typing this I am on wireless but the nm icon says the network is disconnected. (bullwinkle pts14) $ rpm -qa | grep -i networkmanager NetworkManager-glib-0.6.2-2.fc5 NetworkManager-gnome-0.6.2-2.fc5 NetworkManager-0.6.2-2.fc5 (bullwinkle pts14) $ 03:00.0 Ethernet controller: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01) Subsystem: PROXIM Inc Unknown device 0a40 Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 168 (2500ns min, 7000ns max), Cache Line Size 20 Interrupt: pin A routed to IRQ 10 Region 0: Memory at 34000000 (32-bit, non-prefetchable) [size=64K] Capabilities: [44] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=2 PME- What do I need to do to get nm to see my wireless card? Regards, Tom Diehl [EMAIL PROTECTED] Spamtrap address [EMAIL PROTECTED] _______________________________________________ NetworkManager-list mailing list NetworkManager-list@gnome.org http://mail.gnome.org/mailman/listinfo/networkmanager-list