On Thu, 2013-09-26 at 15:09 +0800, LovelyLich wrote:
> Thanks Larry for your help.
> iwconfig shows a wireless device.
> here is my output :

What is the "rfkill list" output if, as root, you run "rfkill unblock
wifi"?

Dan

> this dmesg -c output is the only output when i click the 'enable
> wireless' button(of course, it automaticly unchecked again. :( )
> [root@localhost]/home/codedancer# dmesg -c
> [  434.786071] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
> 
> And other command output is below, thanks .
> 
> [root@localhost]/home/codedancer# rfkill list
> 0: acer-wireless: Wireless LAN
>         Soft blocked: yes
>         Hard blocked: no
> 1: phy0: Wireless LAN
>         Soft blocked: no
>         Hard blocked: no
> [root@localhost]/home/codedancer# iwconfig
> wlp3s0    IEEE 802.11bgn  ESSID:off/any
>           Mode:Managed  Access Point: Not-Associated   Tx-Power=16 dBm
>           Retry  long limit:7   RTS thr:off   Fragment thr:off
>           Encryption key:off
>           Power Management:on
> 
> vmnet8    no wireless extensions.
> 
> p4p2      no wireless extensions.
> 
> lo        no wireless extensions.
> 
> vmnet1    no wireless extensions.
> 
> [root@localhost]/home/codedancer#
> 
> 2013/9/26 Larry Finger <larry.fin...@lwfinger.net>:
> > On 09/25/2013 09:28 PM, LovelyLich wrote:
> >>
> >> Hi list,
> >> When I click 'enable wireless', nm will automaticly uncheck the button
> >> before 'enable wireless'.
> >> Even if I try to boot with  ubuntu 13.04 livecd , it still cannot
> >> enable wireless.
> >> here is my laptop info from fedora:
> >> lspci -v
> >> 03:00.0 Network controller: Qualcomm Atheros AR9485 Wireless Network
> >> Adapter (rev 01)
> >>          Subsystem: Lite-On Communications Inc Device 6627
> >>          Flags: bus master, fast devsel, latency 0, IRQ 18
> >>          Memory at f7900000 (64-bit, non-prefetchable) [size=512K]
> >>          Expansion ROM at f7980000 [disabled] [size=64K]
> >>          Capabilities: [40] Power Management version 2
> >>          Capabilities: [50] MSI: Enable- Count=1/4 Maskable+ 64bit+
> >>          Capabilities: [70] Express Endpoint, MSI 00
> >>          Capabilities: [100] Advanced Error Reporting
> >>          Capabilities: [140] Virtual Channel
> >>          Capabilities: [160] Device Serial Number 00-00-00-00-00-00-00-00
> >>          Kernel driver in use: ath9k
> >>
> >> ethtool -i :
> >> [root@localhost]/home/codedancer# ethtool -i wlp3s0
> >> driver: ath9k
> >> version: 3.9.5-301.fc19.x86_64
> >> firmware-version: N/A
> >> bus-info: 0000:03:00.0
> >> supports-statistics: yes
> >> supports-test: no
> >> supports-eeprom-access: no
> >> supports-register-dump: no
> >> supports-priv-flags: no
> >> [root@localhost]/home/codedancer#
> >>
> >> Please help me , thanks .
> >> if you need more info, just let me know.
> >
> >
> > Two things that suppress wireless come to mind.
> >
> > Does iwconfig show a wireless device? If not, you may be missing the
> > necessary firmware. Check the output of dmesg to see if there are any
> > messages regarding missing firmware.
> >
> > Does "rfkill list" show anything blocked?
> >
> > Larry
> >
> >
> _______________________________________________
> networkmanager-list mailing list
> networkmanager-list@gnome.org
> https://mail.gnome.org/mailman/listinfo/networkmanager-list


_______________________________________________
networkmanager-list mailing list
networkmanager-list@gnome.org
https://mail.gnome.org/mailman/listinfo/networkmanager-list

Reply via email to