On Fri, Feb 05, Dan Williams wrote: > Can you grab some NM log output? the NetworkManager openvpn plugin > does have support for IPv6, but we need to figure out if: > > 1) NM or NM-openvpn is somehow ignoring your request to have them > ignore IPv6 configuration
In nm-connection-editor I had set IPv6 to "Ignore", which I interpreted as "whenever the peer offers ipv6, just ignore that offering". So this interpretion of "ignore" was wrong. Not sure which part of the system does actually apply the offered addresses and routes. Are you saying there might be some sort of autoconfiguration going on, like it could be done for wired connections? Once I changed it to "Automatic (VPN)" the "Routes ..." knob appeared. Here the default is for "Use the connection only for resources for this network" is disabled. Once I checked that box, the default route is not applied. I did the same already for ipv4 to avoid that all traffic goes through tun0. For short: now that I have the checkbox for "Use the connection only for resources for this network" enabled my connection works as expected. If something can be done about the misleading "Ignore", that would be great. Olaf _______________________________________________ networkmanager-list mailing list networkmanager-list@gnome.org https://mail.gnome.org/mailman/listinfo/networkmanager-list
