I can't tell you how to force LM to set the card into full-duplex, but I can tell you that normally, a NIC's autodetect works pretty well. The card should try to negotiate the best signalling speed and duplex level that it can. If it did not autodetect full duplex, then it is highly likely that your hub/switch does not support that communication mode.
On Wednesday 14 August 2002 07:46 pm, Duke Glover wrote: > Hello Mandrake gods, > > I am running Mandrake 8.0 on a HP Kayak XM600. I have a linksys LNE100TX. > mii-tool reports that it is running at 10Mbit, half duplex. How can I set > it to run at Full Duplex ? > > Thanks for any help, > > Duke
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com