On Tuesday 27 May 2003 10:02 pm, Olli Mäntyranta wrote: > Hi! > > I have a Mdk9.0 installed, and while installing the system I > also installed the StarOffice6 . > When I try to launch, let's say 'swriter' in > /usr/lib/staroffice/programs , otherwise than root, it just > doesn't start. If I write the command in shell, I am told > about asegmentation fault. > > What should I do to make all users being able to use > StarOffice? > > Thanks in advance, > OllimaX!
When installing SO you have to enable it's networking capability to allow all users acces. To do so, become root, go to the directory where you have all the binaries ( its located a few directories below the main one), find the file named *setup*. - And - at this point, I would open a console, su into root, verify once again that the *setup* file is there ( easy : type ls setup) and then issue the command : setup -net (earlier on, in my OS/2-days it was setup /net, so if one doesn't work, try the other). This should open the installation process, enjoy. Then - if everything goes OK, back out of root (close all windows) and as a normal user, go back to the very same directory once again. Now, issue the command : setup. That way you'll only install about 1.5 MB in every users /home/user directory. Very cool. HTH Kaj Haulrich. -- Registered Linux user # 214073 at http://counter.li.org Powered by Linux - Mandrake 9.1 - kernel 2.4.21 Brought to you from my 100 % Micro$oft-free computer.
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com