Pat Patterson wrote:
I hope some one can point me in the right direction. This card uses the TI
chipset and is recognized on boot but does not load. From dmesg I collected
the following:
PCI: Enabling device 0000:02:00.0 (0000 -> 0002)
PCI: Setting latency timer of device 0000:02:00.0 to 64
acx100_probe_pci: WARNING: ACX111 support is highly experimental!
Found ACX111-based wireless network card at 0000:02:00.0, irq:10,
phymem1:0x10820000, phymem2:0x10800000, mem1:0xcfb0f000, mem1_size:8192,
mem2:0xcfb12000, mem2_size:131072.
acx100_probe_pci: using ACX111 io resource addresses (size: 54)
hw_unavailable = 1
acx_show_card_eeprom_id: EEPROM card ID string check found uninitialised card
ID: this is a SpeedStream SS1021 or Gigafast WF721-AEX, no??
reset hw_unavailable++
acx100_reset_mac: enable soft reset...
acx100_reset_mac: disable soft reset and go to init mode...
ERROR: no directory for firmware file specified, ABORTING. Make sure to set
module parameter 'firmware_dir'! (specified as absolute path!)
acx100_reset_dev: Failed to upload firmware to the ACX111
acx100_probe_pci: TI acx_pci: MAC initialize failure!
acx100_probe_pci: TI acx_pci.o: Ver 0.2.0pre8 Loading FAILED
acx_pci: probe of 0000:02:00.0 failed with error -5
It seems that the drivers are not being loaded but I am at a loss as to what
script file calls them or where the drivers are. does anyone see any other
problems I need toaddress?
Thanks
Pat
Have you looked at ndiswrapper?
____________________________________________________
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
Join the Club : http://www.mandrakeclub.com
____________________________________________________
