MAKE SURE that in your bios setup pnp OS is set to "no way jose"
------Original Message------
From: "philomena" <[EMAIL PROTECTED]>
To: Newbie <[EMAIL PROTECTED]>
Sent: April 2, 2000 5:17:37 AM GMT
Subject: [newbie] network card detection
Hi,
I have Mandrake 6.1 and just got DSL. I installed the network card before
doing a clean install - its a Linksys Network Everywhere NC100 fast ethernet
10/100 PCI card. During install, the card was not be detected. I didn't have
the service hooked up at that point - don't know if that makes a difference.
I can't find a linux driver on either the linksys or network everywhere
sites. I did find a section on linksys that says to download/compile/install
tulip driver. But when checking network options in linuxconf tulip is
there - I tried setting it up but still comes back with "failed" at
detecting eth0. Suggestions ?
Also, if I should follow the compile option, the instructions on linksys for
the compile state to include a subdir that I don't seem to find -
"/usr/src/linux/net/inet" - I don't see an "inet" anywhere.
thanks...
philomena
