I thought I had tried everything at this point, but I was wrong (nothing unusual in that). I went into conf.modules and added this line: options ne irq=3 io=0x340 And, viola!, it works. Now to see if the winders machines will work . . . The ultimate bad software title: Microsoft Works. > I'm using the linksys Ether16 10BaseT card and thier website says it uses the > ne driver. That's all well and good, but if I try 'insmod ne io=0x340' I get > the following unresolved symbols: (I also get the error if I leave out the io= > part) > > ei_open > ethdev_init > ei_interrupt > NS8390_init > ei_close > > I'm wondering if this is a problem that I'm causing, a problem with the driver, > or what. > > Ty C. Mixon > F.T.C. Enterprises > [EMAIL PROTECTED] > ICQ 26147713 > > > Ty C. Mixon F.T.C. Enterprises [EMAIL PROTECTED] ICQ 26147713