Hi everybody,
i have a short question on PCMCIA.
I am using the PCMCIA-Version wich was shipped with LM 7.0. It is the
Version 3.1.9.
I bought a AboCom PCMCIA CardBus Networtcard. On installation i left
the Card in the CardBusSlot of my Notebook.
LM 7.0 detects it but "insmod tulip" failed, without any showen error.
After installation i went to "netconf" and set the network up. Here
are my settings.
IP:192.168.1.3
NM:255.255.255.0
Interface eth0
Modul tulip
In lothar the card is recognized too, and in the KDE-Controlpanel the
Card is showen as as
LinkSys 10/100 Fast Ethernet-Card.
The "ifconfig" shows that the interface is up and running using the
IRQ 9. It can ping to itself but not to the other computers.
On startup PCMCIA is started and the LEDīs of the PCMCIA-connector
are on. That shows me that the card is connectet to the 100Mbit
swith in full duplex. But then came the message up "Tx hung 13. vs.
0".
I have tried everythig. I also postet the message-files to the
AboCom-Support. They say that everything is alright and they canīt
understand why this card wont work.
Has someone outthere any suggestion how to solve this probleme?
Thanks
Thorsten
PS.On the basis of my bad english i hope you will understand what
probleme defenatly i have !!!
