Brian,
I recently installed 7.1 and had problems that folks here helped me with.
This is how I set it up to finally work:
> This is what I did in NETCONF.
>
> Basic Host Information
> Host name + domain = linux.myNTserverdomain name
> Adaptor1 = enabled DHCP, net device = eth0, kernel module = 3c574-TX,
Irq=10, all other fields blank
>
> Name server specifications (DNS)
> DNS is required for normal operation (selected)
> default domain = 10.0.0.1
> IP of name server 1 = same DNS address that I use in my other boxes
> IP of name server 2 = same DNS address that I use in my other boxes
> IP of name server 3 = same DNS address that I use in my other boxes
> all other fields blank
>
> Routing and gateways
> Set defaults = enable routing(selected) and Default gateway = 10.0.0.1
>
> I have not done anything with the other NETCONF options
You were not clear in your email what kind of DSL modem you have and if you
have fixed IP addresses of your modem/router supports DHCP using NAT. The
above instructions are assuming the later.
Hope this helps
Jim
----- Original Message -----
From: "Brian Jacob Rogers" <[EMAIL PROTECTED]>
To: "Newbie" <[EMAIL PROTECTED]>
Sent: Saturday, October 28, 2000 7:38 AM
Subject: [newbie] Ethernet and DSL
> Hi all,
> I am a real newbie to trying to set this up. I have a 3com
> ethernet card which is connected to my dsl modem. I have a 2 station
> network with the other one running win98se. I can't seem to
> configure my sound (creative sound blaster audioPCI 128D) or my nic
> (3com Etherlink 10/100). Can anyone offer any advice? Thank you.
> Brian
>
>
>
