What if you add the idedma (or is it dma) switch to the kernel boot
sequence. ie. idedma=100. I know that under LM 7.2, as it is booting, it
says something like "assuming 33Mhz IDE, use XXX switch to change it".
----- Original Message -----
From: "Dan LaBine" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, March 12, 2001 5:23 AM
Subject: Re: [newbie] can 't install on ASUS A7V133
> Michael; Mandrake 7.2 doesn't run properly on the ata100 on the ASUS A7V
> board just yet. I'm running that board on this system. 8.0 may support
> it, but since it's still a Beta product, don't expect it to run properly
> yet. Use the standard IDE interfaces for now. Apparently there is a way
> to make it work on 7.2 but even so it's still "buggy". Try installing
> your O/S using the stabdard interface, and then switching to the ata100
> interface afterwards.
>
> michael wrote:
>
> > With primary ata100 cable connected to both hd's 7.2 won't install, and
> > 8.0 only gets half way thru the second disk. Does anyone have any
> > experience with this board?
>
>
> --
> Dan LaBine
> Maximum L.A.N.'s Ltd
> Registered Linux User #190712
>
>
>
