There were a couple of posts about this chip set on the list about 2 months ago use google on the archives... Lionel --- [EMAIL PROTECTED] wrote: > > Hello -- > > From the number of posts I've seen on usenet, I'm sure this is not a new > issue. I've just installed Slackware 8.0 (with XFree86 4.1.0) on a Dell > GX110 with the intel810 chipset, and, as many before me, XFree86 is proving > difficult to get working. > > First let me say, for some unknown reason I haven't been able to get to > intel's website, so I cannot go take a look at > support.intel.com/support/graphics/intel810/linuxsoftware.htm as suggested. > I don't know if this is one of the censored sites in China (I have no idea > why it might be) but it's been inaccessible to me for hours. Far longer > than "normal" commercial website downtime. If anyone has the contents of > this page and could send it on, it would be most appreciated. > > Otherwise, in my XFree86.0.log, I get various lines about "hsync out of > range" and even a few "bad mode clock", then the "failed to load kernel > module i810" and finally "Fatal server error: AddScreen / ScreenInit failed > for driver 0". > > Most posts on usenet seem to indicate that XFree86 3.3.6 (pardon me if that > version number is wrong) would correct this problem. Therefore, I thought I > was in the clear with 4.1.0. Could someone please tell me if I still need > to re-compile something to include support for the i810? > > Many thanks, > Susan Rajnic > [EMAIL PROTECTED] > _______________________________________________ > Newbie mailing list > [EMAIL PROTECTED] > *** To unsubscribe , or change message options, see: > http://XFree86.Org/mailman/listinfo/newbie
__________________________________________________ Do You Yahoo!? Buy the perfect holiday gifts at Yahoo! Shopping. http://shopping.yahoo.com _______________________________________________ Newbie mailing list [EMAIL PROTECTED] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
