Hi
I could do with some advice on joining field boundaries to roads. I have been
doing this as the mapping style I am use to never has the field boundary
running along the side the road. If the field boundary along the road is well
set back then I would consider drawing it however in most cases it is within a
few meters of the road and sometimes there is not gap at all. I believe the
OSM application can in theory go down to 3m. Drawing a field boundary along a
road where the gap is less than 3 meters between the boundary (wall,fence) and
the end of the road would therefore seem unrealistic.
Should I try and draw the field boundary along the road in all situations or
only do this when there is a large gap > 3m?
If I don't draw the field boundary along the road should I link to the road or
should I stop the boundary just short of the road?
Some guidance would be appreciated as I don't want to link boundaries to roads
if this could cause problems.
Many thanks in advance.
Regards
Dudley
_______________________________________________
newbies mailing list
[email protected]
http://lists.openstreetmap.org/listinfo/newbies
