* Peter Haag > Not that easy. What you can try: > o convert from flow-tools. > o Put NfSen into Sim mode, by setting the proper %sim settings. See > nfsen-dist.conf > o run the simulation for your files. > o stop the simulator - do *not* reset! > o Disable sim mode. > o Restart NfSen. > > It's a rather ugly and manual hack, but the only way at the moment.
Hi again, I finally finished converting all my data files (thanks again for you help!), but unfortunately I had no luck in getting the imported data to show up in the graphs. The data is there and appears to work fine - if I navigate around in the graph selecting timeslots/windows (I had to rebuild the live profile for the imported history to not be "grayed out" and unselectable though), the proper values show up in the statistics table below the graph. But the graph itself is empty. What I did was: 1) Add the following to nfsen.conf: $SIMmode = 1; %sim = ( 'tstart' => '200908030000', 'tbegin' => '200908030000', 'tend' => '201007062355', 'cycletime' => '0', ); 2) Restart NfSen and wait for the simulation to finish (syslog messages about run/end expire are blazing past until it says "simulation ends"). 3) Uncomment the sim settings and restart NfSen. Unfortunately, the RRD files only contain NaN values for the imported dates, which results in empty graphs. I also tried the procedure with first moving the old RRD files out of the way, but they were not re-created. Any further suggestions..? Best regards, -- Tore Anderson Redpill Linpro AS - http://www.redpill-linpro.com/ Tel: +47 21 54 41 27 ------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ Nfsen-discuss mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/nfsen-discuss
