I don't see any washers, just the bushing. I reuse all original washers to maintain the clearances from the builder. I only clean the armature and replace the brushes. Keep everything as it was. The washers are thrust washers and serve to establish an end-play clearance. Dab of grease in the bushing (very little) and reassemble.
--- On Sat, 6/6/09, NghthawkLvr <[email protected]> wrote: From: NghthawkLvr <[email protected]> Subject: [Nighthawk Lovers] any suggestions? .... To: [email protected], [email protected] Date: Saturday, June 6, 2009, 5:54 PM hey guys... any suggestions for removing this washer, and the similar larger one in the other end...to replace them with the new ones in the rebuild kit? what do y'all think... thanks again... NghthwkLvr 6JUNE09_STARTER PICS 003.jpg 6JUNE09_STARTER PICS 004.jpg These pictures were sent with Picasa, from Google. Try it out here: http://picasa.google.com/ --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en -~----------~----~----~----~------~----~------~--~---
