Hello,
I would like to add the IP address 172.16.48.17/28 to my enp0s3
interface but I would also like to keep the DHCP configured address. I
tried the following:
networking = {
interfaces.enp0s3 = {
useDHCP = true;
ip4 = [
{ address = "172.16.48.17";
prefixLength = 28;
}
];
};
};
But after a "nixos-rebuild switch" ifconfig doesn't show the additional address:
$ ifconfig enp0s3
enp0s3: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.42.225 netmask 255.255.255.0 broadcast 192.168.42.255
inet6 fdf1:4004:db11:1:a00:27ff:fe34:fdef prefixlen 64
scopeid 0x0<global>
inet6 fe80::a00:27ff:fe34:fdef prefixlen 64 scopeid 0x20<link>
ether 08:00:27:34:fd:ef txqueuelen 1000 (Ethernet)
RX packets 214736 bytes 67482409 (64.3 MiB)
RX errors 14 dropped 0 overruns 0 frame 0
TX packets 46641 bytes 7880848 (7.5 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 19 base 0xd020
Is this possible or should I use networking.localCommands?
Cheers,
Bas
_______________________________________________
nix-dev mailing list
nix-dev@lists.science.uu.nl
http://lists.science.uu.nl/mailman/listinfo/nix-dev
