Hi, I am just using ovswitch from mininet and not starting any components. But i have connected the switches to the controller just that i dont run any component except the running the nox controller itself.
I will try running the pyswitch component and see whether works or not. Thanks! Regards, Anthony On Sat, Jun 9, 2012 at 6:51 AM, Kyriakos Zarifis <[email protected]>wrote: > The controller should be reachable by the switches so that the openflow > channel can be established between each of them and the controller. You > shouldn't be able to ping between hosts if the switches haven't connect to > a controller that runs a forwarding algorithm. > What kind of switches are you using? And what command are you using to > start NOX (do you start any forwarding components like e.g. pyswitch ) ? > > > On Fri, Jun 8, 2012 at 7:31 AM, Anthony Salim < > [email protected]> wrote: > >> Hi, >> >> Thanks. I have one question. I give controller an IP address of >> 10.0.0.250 and the hosts are 10.0.0.x range but i could not ping the from >> one host to another. But if the controller using defaultIP which is the >> loopback address, it will have no problem. How do i resolve this? Thanks. >> >> Regards, >> Anthony >> >> >> On Fri, Jun 8, 2012 at 8:25 PM, Kyriakos Zarifis >> <[email protected]>wrote: >> >>> Hi, >>> >>> there is no spanning tree running by default (unless you start NOX with >>> the spanning_tree module) >>> >>> >>> On Fri, Jun 8, 2012 at 4:13 AM, Anthony Salim < >>> [email protected]> wrote: >>> >>>> HI all, >>>> >>>> How can i disable STP in nox controller? Thanks. >>>> >>>> Regards, >>>> Anthony >>>> >>> >>> >> >
