Hi Marlos, I am not sure but this link<http://tagus.inesc-id.pt/%7Epestrela/ns2/ns2_haddr_tips.html#_Toc121548868>says that the addresses must be in the X.Y.Z format ?
On Wed, Nov 5, 2008 at 14:03, Marlos Marques <[EMAIL PROTECTED]>wrote: > > Hello all, > > Currently, I am trying to implement an application layer multicast > algorithm > using NS2. For this purpose I need to assign IP address to every node in > NS2. I checked out the NS2 nodes may have hierarchical routing addressing > which is similar to IP addressing. But, I also found the "addr" command > which apparently allows you to configure the node IP, so I can run the > following code: > > set ns [new Simulator] > set n0 [$ns node] > set n1 [$ns node] > $n0 addr "192.168.1.1" > $n1 addr "192.168.1.2" > > But in the trace file I keep getting sequential identifiers. For example: > > + 0 1 2 tcp 40 ------- 2 1.0 5.0 0 0 > > But I would like to get this one: > > + 0 192.168.1.1 192.168.1.2 tcp 40 ------- 2 1.0 5.0 0 0 > > What am I doing wrong? > > > Thanks in advance, > Marlos > -- Ramy Eid