Falk,
pls. don´t give up ! I´m still using gcc 3.0.4 preported from HP porting centres http://hpux.asknet.de/ on a 715 CX 100. Dear Ladies and Sirs, this is my build status: - buildall.sh phasis completed without errors and warnings - rrdtool did not build because it needs HP Ansi CC for the perl modules. I´m still trapped in this issue. I had not time to care for HP Ansi CC install images. - A perl build from scratch on HP-UX with gcc is not supported by perl team - ntop configure did not detect openssl on its default location, I posted this, but I received no feedback from Burton or other developers. - multithread mode was correctly detected - make phasis (build) stopped within util.c (all messages from make phasis attached as make.results.gz ) This is my old status, solution: actual cvs ! or put a a space between ...P and ( Do you use HP-UX 11 ? I can't do a downgrade to this old gcc, perhaps you can do an update to this: autoconf 2.57 automake 1.7.2 bison 1.875 flex 2.5.4a gawk 3.1.1 gcc 3.2 libiconv 1.8 libpcap 0.7.1 libtool 1.4.3 m4 1.4 make 3.79.1 perl 5.8.0 samba 2.0.7 sed 4.0.3 tcpdump 3.7.1 texinfo 4.2 Stefan ********************************************************************** Diese Nachricht wurde erfolgreich mit Sophos-Sweep auf Viren gescannt. Wir übernehmen keine Garantie für die Virenfreiheit dieser Nachricht, oder der damit transportierten Dateien. Bei Fragen zu diesem System wenden Sie sich bitte an [EMAIL PROTECTED] This Mail was checked for Viruses with Sophos-Sweep. Although this procedure secures a relative high level of protection, we cannot take any responsiblity for malicious code or viruses contained within the mail itself or attachments. For further information contact [EMAIL PROTECTED] ********************************************************************** _______________________________________________ Ntop-dev mailing list [EMAIL PROTECTED] http://listgateway.unipi.it/mailman/listinfo/ntop-dev
