I normally start ntop with --interface ppp0,eth1,wlan0,lo eth0 is up but does not require an IP address. eth0 connects to an ADSL modem which is in bridge mode. I use Roaring Penguin's PPPoE software to connect to the internet(I use version rp-pppoe-3.5-23.cc, the latest version is rp-pppoe-3.10 which is available from: http://www.roaringpenguin.com/products/pppoe). When PPPoE successfully connects it creates the ppp0 interface.
I get this error from ntop: Sun Nov 23 09:57:56 2008 LASTSEEN: Welcome to Host Last Seen. (C) 1999 by Andrea Marangoni Sun Nov 23 09:57:56 2008 **WARNING** Plugin '/usr/local/lib/ntop/plugins/lastSeenPlugin.so' contains a wrong filter specification Sun Nov 23 09:57:56 2008 **WARNING** "ip or (vlan and ip)" on interface ppp0 (no VLAN support for data link type 113) Sun Nov 23 09:57:56 2008 The filter has been discarded and the "Host Last Seen" then isn't present in the Plugins menu: http://i37.tinypic.com/2ilfy1k.jpg Can this filter be modified/fixed to work with ppp0? [EMAIL PROTECTED] ~]# ifconfig eth0 Link encap:Ethernet HWaddr 00:03:47:A1:87:56 inet6 addr: fe80::203:47ff:fea1:8756/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:790663 errors:0 dropped:0 overruns:0 frame:0 TX packets:682054 errors:0 dropped:0 overruns:0 carrier:0 collisions:920 txqueuelen:1000 RX bytes:856015670 (816.3 MiB) TX bytes:69116572 (65.9 MiB) ppp0 Link encap:Point-to-Point Protocol inet addr:220.233.224.217 P-t-P:220.233.1.150 Mask:255.255.255.255 UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1 RX packets:77691 errors:0 dropped:0 overruns:0 frame:0 TX packets:63585 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:3 RX bytes:88383571 (84.2 MiB) TX bytes:6574157 (6.2 MiB) _______________________________________________ Ntop-dev mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop-dev
